Standard PLA is the easiest filament in the world to print, and also the first one to let you down the moment a part has to do real work. PLA+ (what we call PLA Enhanced) is the fix: the same forgiving behaviour on the bed, with noticeably better layer adhesion and impact resistance.
It is also a high-flow formula, which matters more than most people expect. If your printer can move quickly, a high-flow PLA is what lets it actually do so without under-extruding.
What PLA+ actually improves
Three things, in order of how much you will notice them:
- Layer adhesion. This is where standard PLA fails first. Parts snap along layer lines under modest load. PLA+ bonds better between layers, so a bracket or clip survives being flexed.
- Impact resistance. Standard PLA is brittle. Drop a print and it shatters. PLA+ absorbs a little more before it gives up.
- Flow rate. The formula is tuned to extrude cleanly at higher speeds, so fast profiles stop producing gaps and weak walls.
What it does not change: heat resistance. PLA+ is still PLA. Leave a part in a car in a Lebanese summer and it will sag. If heat is the problem, you want PETG or ASA instead.
EMBERFORM PLA Enhanced at a glance
| Diameter | 1.75 mm (±0.03 mm) |
| Net weight | 1 kg |
| Spool length | ~340 m |
| Nozzle temperature | 190-210 °C |
| Bed temperature | 50-80 °C |
| Price | $12 per spool |
Start at 200 °C and move in 5 °C steps. Hotter improves layer bonding; cooler improves fine detail. A heated bed is not strictly required but it makes first layers far more reliable.
What to print with it
PLA+ is the sensible default for most of what comes off a hobby printer: prototypes, miniatures, household fixes, props, organisers, and any print where you want a good surface finish without babysitting the machine. It is also the right pick for high-volume printing, because the speed advantage compounds across a long queue.
It comes in 13 colours, which makes it the practical choice when you need a specific colour to match something rather than whatever the shelf has.
Getting the most out of it
- Run cooling at or near full. PLA likes it, and it sharpens overhangs and small details.
- If you are chasing speed, raise temperature before you raise flow. Under-extrusion at high speed is almost always a heat problem.
- Store spools sealed with desiccant. PLA is not as thirsty as nylon, but damp PLA still prints rougher and sounds like it is popping.
Buy it in Lebanon
EMBERFORM PLA Enhanced is $12 for a 1 kg spool, in stock and shipping across Lebanon for a flat $5, typically in 3-4 days. We accept Cash on Delivery and Whish.
Not sure this is the right material? The filament materials guide compares every EMBERFORM filament side by side, or browse engineering filaments and display filaments.